Publicidad
Idiomas disponibles
Idiomas disponibles
HANDLE BAR ASSEMBLY
Unscrew the bolt, connect the main cable together (please carefully align the
male port and the female port), insert the handlebar into the stem tube, screw
in the bolt, and then securely tighten it with two Hex spanners. The required
clamping/tightening force is between 5 to 7 N/m.
Note: Please ensure that the hole is not blocked by the cable when you screw
in the bolt.
WARNING! RISK OF INJURY BY PINCHING!
DO NOT INSERT YOUR FINGERS INTO THE SHADED AREA INDICATED.
FOLD THE SCOOTER
1. Press the red button located on the folding lever, and open the folding lever.
2. Lower the t-bar until the hooked handlebar is clipped into the rear wheel fender.
Caution: Before lifting the scooter, ensure the hook of the t-bar is securely placed into the rear wheel fender.
The folding mechanism may loosen after some time of use. In this case, use the supplied hex wrench to tighten the bolt gradually.
5 - CHARGING
When the battery indicator light on the LCD becomes low, you can recharge the battery with the provided charger.
IMPORTANT:
The battery has the feature of temperature protection.
If you try to charge the scooter just after riding, the battery pack might be at a high temperature, and it will not accept charging until about 25 minutes later when the battery pack cools down.
Warning for battery charging: Use only the charging device provided with your scooter.
Your electric scooter is delivered with a specific charger; do not use any other charger with the scooter. Only charge the scooter indoors. The external flexible cable of this charger cannot be replaced; in
case of damage, the charger must be disposed for recycling.
1. To charge your electric scooter, make sure it is turned off by switching OFF; then remove the waterproof cap from the port and plug in the charger. For safety reasons, ensure the charging port is always
dry before starting to charge.
2. Plug the charger into a suitable power source.
3. When the LED light on the charger is red, the battery is charging.
4. When the signal light changes to green, the battery is fully charged; this will take approximately 5-6 hours. You must stop charging it when the signal light turns green; charging the battery for too long will
reduce its lifetime.
1
2
The protective cover is used to protect the charging port from splashing water. Be sure to replace the cap after each charging and before each use.
- Children should not play with the battery appliance.
(model ref. CP4215)
3
4
ENGLISH
7
Publicidad
