cecotec BOLERO HEXA P506000 EDGE A+ Manual De Instrucciones página 54

ENGLISH
1. Open the door and switch on the inside light by pressing the
2. Clean the baking tray, accessories and side guides with warm water and liquid detergent
and dry them with a soft, clean cloth.
3. Wipe the inside of the oven with a soft, clean cloth.
4. Wipe the front of the oven with a damp cloth.
5. Make sure that the oven accessories are in place and operate the oven in convection
mode at 200 °C for 1 hour before use.
NOTE:
Make sure that the room is well ventilated during this preparation process. It is possible that
during the operation of the oven you will perceive a characteristic odour; this is normal.
Oven guides
- The oven guides are numbered from bottom to top.
- 4th and 5th guides are mainly used for grill function.
Accessories
1. Oven rack. For plates, cake tins, roasting and grilling trays.
2. Baking tray. For cakes and cookies.
- The rack and baking tray must be placed correctly on the side guides. Be careful when
removing the trays/containers from the oven, as they are very hot surfaces, and you could
burn yourself.
- If you use a deep pan or baking tray to collect the fat that falls from the food, make sure
that it is placed correctly on the side guides. Allowing these accessories to come into
contact with the bottom surface of the oven may damage the enamel.
- If you place trays or containers on the first guide starting from the bottom, you must leave
a distance of at least 2 cm from the bottom surface of the oven.
3. Basket. Use this accessory with the Air Fry mode: this basket can be placed on the oven
rack or on the side guides in the same way as the tray.
3. INSTALLATION
- To ensure the correct operation of the appliance, make sure the piece of furniture is suitable
for built-in installation. Figure 2 shows the adequate size of the hole for installation under
a worktop or in a wall unit.
- To ensure adequate ventilation, the rear panel of the cabinet must be removed. It is
preferable to install the oven so that it rests on two wooden slats. If the oven rests on a
flat surface, there must be an opening of at least 45×560 mm, like shown in figure 3.
- Adjacent cabinet panels shall be made of heat-resistant material. In particular, enclosures
54
Bolero Hexa P506000 Edge A+
Bolero Hexa P506000 Matt A+
icon.