cecotec BOLERO HEXA P506000 EDGE A+ Manual De Instrucciones página 55

with a veneered exterior must be assembled with glues that can withstand temperatures
up to 100 ˚C.
- In compliance with current safety regulations, it must not be possible to come into contact
with the electrical parts of the oven once it has been installed.
- All parts that ensure the safe operation of the appliance must only be removed with the
aid of a tool.
- To fix the oven to the cabinet, open the oven door and fix it by inserting the 4 screws into
the 4 holes on the perimeter of the frame.
Electrical connections
Ovens equipped with a three-pole power cable are designed to operate on alternating current.
The earth wire of the appliance is yellow green.
Mounting the power cable
Fig. 4
Open the terminal board:
- With a screwdriver, tighten the screw on the side tabs of the terminal board cover.
- Unscrew the screws on the side tabs of the cover and remove the latter.
To install the power cable, proceed as follows:
- Remove the cable clamp screw and the three contact screws.
- Fix the wires under the screw heads using the following colour scheme: Blue (N) Brown
(L) Yellow Green.
- Secure the power cable with the cable clamp and close the terminal board cover.
Connecting the power cable to the mains
- When connecting the cable directly to the mains, install an omnipolar circuit breaker with
a minimum contact opening of 3 mm between the appliance and the mains. The omnipolar
circuit breaker must be sized according to the load and comply with the applicable
regulations (the earth cable must not be interrupted by the circuit breaker).
- The power supply cable must be routed so that it does not reach a temperature above 50
˚C above ambient temperature and must be protected by insulation with an appropriate
rating. Before making the connection, check that:
- The electrical safety of this appliance can only be guaranteed if the oven is correctly and
effectively earthed in accordance with electrical safety regulations. Always make sure
that the ground connection is effective; if in doubt, call a qualified technician to check the
system. The manufacturer declines all liability for damage resulting from an ungrounded
system.
- Before connecting the appliance to the mains, check that the specifications indicated on
the rating plate (on the appliance and/or on the packaging) correspond to those of the
mains supply at home.
ENGLISH
Bolero Hexa P506000 Edge A+
Bolero Hexa P506000 Matt A+
55