Oerlikon CITOSTEEL 255C Manual De Instrucciones página 13

Output Connections
Refer to points [3], [4] and [5] of the Figures below.
Controls and Operational Features
Front Panel
Basic Version
Figure 1.
1. U0 User Interface: See "User Interfaces" Chapter.
2. Power Switch ON/OFF (I/O): Controls the input power
to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I"). After input power is connected and the power
switch is turned on, the indicator will light up to
indicate the machine
3. Negative Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
4. Positive Output Socket for the Welding
Circuit: For connecting an electrode holder
with lead / work lead.
5. EURO Socket: For connecting a welding gun (for
GMAW / FCAW process).
English
is ready to weld.
Front Panel
Pro Version
6. U7 User Interface: See User Interfaces chapter.
7. Remote Control Connector Plug: To install Remote
Control Kit. This connector allows connection Remote
Control. See "Accessories" chapter.
Rear panel
8. Wire Liner Entry: Enables installing liner for welding
wire delivered in drum package.
9. Chain: To protect gas bottle.
9
Figure 2.
Figure 3.
English