Publicidad
Idiomas disponibles
Idiomas disponibles
Limits
– it allows the operator to set the
limits of main welding parameters in selected
job. The Operator is able to adjust the
parameter value within specified limits.
Note: The Limits can be set only for the programs stored
in the user memory.
The limits can be set for:
Welding Current
Wire Feed Speed
Welding Voltage
Wave Controls
To set the range:
Enter to the Settings and Configuration Menu.
Use The Right Knob [36] to higlight the "Limits" icon.
Figure 36.
Press the Right Knob [36] to confirm. List with
avaliable job wil be displayed on the screen.
Figure 37.
Use the Right Knob [36] to highlight the job.
Press the Right Knob [36] to confirm selection.
Figure 38.
English
Use the Right Knob [36] to choose the parameter
which will be changed.
Press the Right Knob [36] to confirm.
Use the Right Knob [36] to change the volue. Press
the Right Knob [36] to confirm.
Figure 39 shows the effect of changing the values of
parameters.
Press the Button [37] to exit with changes.
Display Configuration
Two Display Configuration are available:
Table 13.
Standard view
Advanced view
To set the Display Configuration:
Access to the Settings and Configuration Menu.
Use the Right Knob [36] to highlight the Display
Configuration icon.
24
Figure 39.
Figure 40.
English
Publicidad
