Oerlikon CITOSTEEL 255C Manual De Instrucciones página 35

P.81 Electrode Polarity
P.99 Show Test Modes
P.323 System Update
English
Used in place of DIP switches for configuration of the work and electrode sense
leads

"Positive" (default) = Most GMAW welding procedures use Electrode
Positive welding.

"Negative" = Most GTAW and some inner shield procedures use Electrode
Negative welding.
Uses for calibration and tests.

"No" (factory default) = Turned off;

"Yes" = Allows to selection test modes.
Note: After the device has been restarted the P.99 is "NO".
This parameter is active only when the USB Memory Stick (with upgrade file) is
connected to USB socket.

Cancel – goes back to Configuration Parameters menu

Accept – starts updating process
31 English