Publicidad
Idiomas disponibles
Idiomas disponibles
D
4.0-1
E
4.1-2
F
4.1-4
4
4.1-5
Layout
3
4.1-3
2
3
D.
• Use the adjustment knob (3, Fig. 4.0-1) to position
the tool according to the wheel diameter.
E.
• The locking lever allows locking the tool in the work
position. Lower the lever to release (Fig. 4.1-2) and
lift it to lock (Fig. 4.1-3).
F.
Press the inflator pedal (1, Fig. 4.1-4) half way down:
air will come out of the inflation hose end only (2).
Press the button on the Tubeless Beading Nozzle
(3, Fig. 4.1-5), then press the pedal all the way down
quickly (1, Fig. 4.1-4); a high pressure air jet will exit
the Tubeless Beading device.
DANGER OF HAND CRUSHING
CAUTION: HOLD THE TUBELESS BEADING
NOZZLE FIRMLY.
Note: Air simultaneously continues to exit the hose
connected to the tire.
CAUTION: ONCE BEADING IS COMPLETE,
IMMEDIATELY STOP INTRODUCING AIR.
WHEN OPERATING THE BEADING DEVICE IT
IS MANDATORY TO WEAR EAR PROTECTORS
A N D S A F E T Y G L A S S E S T O P R E V E N T
CONTAMINATION FROM NOISE, DUST AND
CHIPS BLOWN BY THE AIR jET.
DANGER OF TIRE EXPLOSION
EN -
19
Publicidad
