P/N: EAL0424G33A
P/N: EAL0383G35A P/N: EAL0408G44A
P/N: EAL0383G34A
8
- EN
Safety
P/N: 8-23562A
1.1
Safety Label
CAUTION: MAKE SURE THAT THE SAFETY
SIGNS ARE ALWAYS CLEARLY VISIBLE IN THE
POSITIONS INDICATED BY THE MANUFACTURER.
For any reset, use the Part Number (P/N) listed in this
chapter.
EAL0424G33A
(Danger Plate)
Indication to refer to the documentation.
•
Refer to the Operator's Manual to understand the symbols
on the plate and the areas of the equipment they refer to.
The supplied documentation is essential for proper
•
machine Use and Maintenance.
•
In case of doubts or uncertainties, stop the operations
and read the specific manuals.
The codes of the documents supplied with the machine
•
are indicated on page 2 of this Manual. Request a copy
of the documents if they should prove unreadable.
READ AND UNDERSTAND THE INDICATIONS
PROVIDED IN THE DOCUMENTATION BEFORE
PERFORMING ANY OPERATION.
EAL0383G35A - EAL0408G44A
Risk of flying fragments during beading.
The use of the bead seater device could cause the
•
ejection of objects and a high acoustic pressure. We
therefore recommend the use of protection equipment
for eyes and ears.
When using compressed air for the beading operation
•
there is also the risk of the tyre exploding.
Avoid excessive pressure. Do not exceed the maximum
•
pressure indicated by the tyre manufacturer.
The risk of outbreak also depends on the general
•
conditions of the tyre and the rim. Check the tyre before
inflating it.
The bursting of tyres can cause serious injury or death.
EAL0383G34A - 8-23562A
Risk of electric shock from live machine.
•
Do not use equipment with a damaged power cord or
other electrical or mechanical damage until it has been
examined by a service technician authorised by the
manufacturer.
•
Unplug equipment from electrical outlet when not in use.
Never pull the cord to remove the plug from the outlet.
Grasp plug and pull to disconnect it.
•
Do not expose the equipment to rain. Do not use on damp
surfaces.
•
Plug unit into the correct power supply outlet.
•
Do not remove or bypass the earth connection.
Risk of electrical shock. High voltages are present within
the unit.
•
There are no user serviceable items within the unit.
•
Servicing on the unit must be performed by qualified
personnel.
•
Do not open any part of the unit other than known and