Babyauto Dadou LB 383 Manual De Uso página 23

5. ADJUSTING CHILD SEAT.
Fastening & Unfastening the harness
1. Join the 2 buckle metal connectors, pass both connectors through
the slot in the upper part of the buckle until you hear a "click" (5.1).
2. To unfasten the harness press the red button on the buckle
downwards (5.2).
Loosening the harness
3. Release the buckle by sliding the red
the same time pulling out the harness (5.3).
Tightening the harness
4. Pull the harness straps up to remove the slack from the lap section
of the harness, then pull the harness regulating strap until the
harness is fully stretched (5.4).
5. The harness should be as tight as possible without causing
discomfort to your child.
6. Make sure the lap section of the harness is positioned as low as
possible, surrounding your child's hips and not his stomach.
7. A harness that is not properly tightened can be dangerous. Check
the harness adjustment and tighten whenever you put your child
in the child safety seat.
Changing the harness height
8. Place the child on the seat (5.5).
9. Check the height of the shoulder straps for correct position, the
shoulders straps must be thread through the slots in the cover and
seat shell that are closest to the top of your child´s shoulders (5.6).
10. Adjust the height of the harness, by pressing the harness
adjustment button and pulling the harness straps towards you to
loosen them (5.7).
11. Then unhook one of the harness connector straps at the back of
the seat and pull the loose strap towards the front of the seat (5.8
& 5.9).
12. Insert the harness strap into the
at the front of the seat. Then insert the harness strap into the
appropriate upper or lower slot at the rear of the seat (5.10 & 5.11).
13. Reinsert the harness strap in the harness connector on the back
of the seat (5.12).Then, do the same with the other harness strap.
Group 0+/1
F button downwards and at
A slot of the fabric and backrest
www.babyauto.com
EN
23