Publicidad
Idiomas disponibles
Idiomas disponibles
•
When grinding anti-magnetic material such as aluminium alloy, graphite, etc., please use a
suitable clamping block to hold the workpiece in place and ensure that it cannot touch the
disc.
Before grinding, check that the magnetic clamping plate holds the workpiece firmly and
•
permanently.
The worktable must be stationary when the operator adjusts the travel with the adjustment
•
cams.
When wet grinding, the coolant unit should be switched off before the spindle motor is
•
braked.
•
When using coolants, follow the manufacturer's instructions and use a skin protectant if
necessary.
•
Note that an electromagnetic field is generated when using the magnetic chuck. This can
have an effect on active implants (e.g. pacemakers, defibrillators).
15.7
Hazard warnings
Despite intended use, certain residual risks remain when operating the machine. Due to the
design and construction of the machine, hazardous situations may occur which are identified as
follows in these operating instructions:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
15.8
Residual risks
Grinding wheel damage
•
Throwing away workpieces or grinding wheel parts at high speed.
•
-
Always check workpieces for suitability and clamp them securely and firmly
Risk of tripping due to supply lines on the floor.
•
-
Properly route supply lines and cables
-
Mark unavoidable tripping hazards yellow-black
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation of
the machine. Safe working primarily depends on you!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
D AN G E R
WAR N I N G
C AU TI O N
N O TE
SAFETY
42
FSM25AUTO
Publicidad
