Before start of work or
after every maintenance or
servicing
After every operation
Weekly
Semi-annually or after
every 500 operating hours
As needed
20.1.1
Hydraulic system
Supply the hydraulic system with hydraulic oil (recommended for ISO VG 46, DIN 51524 part 2 HLP
46, US Steel 126/127) with a viscosity of 46.
20.1.2
Central lubrication
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Hydraulic unit
Guide ways
Magnetic chuck
Grinding table
Working area
Cabinet
Central lubrication
Hydraulic unit
Levelling machine
Coolant
Grinding wheel
Lubricants are toxic and must not be released into the environment!
Always follow the manufacturer's instructions and, if necessary, contact
your local authority for information on proper disposal.
Fill in the machine oil with a viscosity of ISO 32
(recommended for ISO VG 32, DIN 51524/2 HLP, DIN 51517-3
CLP) via the filler opening (1).
Oil level must always be between min and max (2).
Check oil level
Visual inspection of lubrication
Clean
Clean and remove grinding swarf
Clean and remove grinding swarf
Check for dryness and cleanliness
Check oil level
Change oil
Relevelling if necessary
Fill in
Dressing, balancing or changing
N O TE
The spindle (1) is service-free. The heat-
•
resistant grease does not need to be
changed.
The hydraulic oil for hydraulic pump is in the
•
hydraulic tank (3).
First oil change after 100 operating hours, then
semi-annually or after every 500 operating
hours.
MAINTENANCE
55
FSM25AUTO