Publicidad
Idiomas disponibles
Idiomas disponibles
WORK PAGE:
PREPARE PAGE:
18.3.3
Clamping a workpiece
a. Using the magnetic chuck
If the workpiece is not magnetisable or only slightly magnetisable, use appropriate
fixings. (clamping devices, ...)
b. On worktable without magnetic chuck
Remove the magnetic chuck by loosening the screws
•
Use an appropriate clamping device to fix the workpieces
•
The clamping device must not collide with the grinding movement!
(is not included in the delivery content)
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Display and settings:
• Position Z-Axis
• Rise up value
• WORK POSITION
• ROUGH GRINDING
• FINE GRINDING
• SPARK OUT
• Impulse hand wheel height adjustment (Multiple)
• Single grinding mode
• Switch to "PREPARE PAGE"
NOTE:
The basic parameter are factory settings and
this setting is not allowed to change at any time!
• Switching on hydraulic pump, coolant pump and
grinding wheel
• Y-axis travel on/off (Y-Axis open/close)
• Switch to "WORK PAGE"
• Open the grinding table guard
• Clean thoroughly before use
(use cleaning scraper)
Each small unevenness can negatively
influence the grinding result!
• Place the workpiece (1) on the desired
position of the cleaned magnetic chuck.
• Set the selector switch magnetic chuck (2)
to magnetize.
• Check that the workpiece is firmly seated
• Close the grinding table guard again
(Pay attention to the position switch!)
ATTE N TI O N
N O TE
OPERATION
50
FSM25AUTO
Publicidad
