Publicidad
Idiomas disponibles
Idiomas disponibles
WA
White corundum; for tough steels over 60HRC (tool steel) and all steels that require a
cool grind.
F
Fine pores
46
Middle grain (Average grain size 0,35mm)
L
Hardness medium hard
6
Structure medium
V
Bond ceramic; resistant to water and oil
40 MS
Peripheral speed of the grinding wheel 40m/s
Generally applies:
The harder the material, the softer the degree of hardness and vice versa.
19 CLEANING
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the device after each use of chips and dirt particles.
20 MAINTENANCE
Danger due to electrical voltage! Handling the machine with the power supply up may
result in serious injury or death. Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against unintentional
restart!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless, any faults
or defects which may affect the safety of the user must be rectified immediately!
•
Before each start-up, make sure that the safety devices are in perfect condition and
function properly.
•
Check all connections for tightness at least once a week.
•
Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
Use only proper and suitable tools.
•
•
Only use original spare parts recommended by the manufacturer.
20.1
Inspection and maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the specified limits:
Interval
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O TE
N O TE
WAR N I N G
Component
What to do?
CLEANING
54
FSM25AUTO
Publicidad
