Ninja WOODFIRE Pro Connect XL Instrucciones página 26

PARTS & ACCESSORIES
A Main Unit
B Lid
C
Smoker box
D Control Panel
A
E ON/OFF Switch
F Built-in Probe
G
Power cord and RCD
plug
H Onboard Probe storage
I Grill Plate
J Pellet Scoop
F
K Grease Tray Liner
L Crisper Basket
M
Grease Tray
H
I
L
To order replacement or additional parts and accessories, visit ninjakitchen.eu
BEFORE FIRST USE
1
Remove all packaging material, and tape from the unit.
2 Remove all accessories from the package and read this manual carefully. Please pay particular
attention to operational instructions, warnings, and important safeguards to avoid any injury or
property damage.
3 Wash the grill plate and crisper basket in warm, soapy water, then rinse and dry thoroughly. The grill plate,
crisper basket and base unit are NOT dishwasher safe. NEVER clean the main unit in the dishwasher.
4 DO NOT use abrasive brushes or sponges on the cooking surfaces, as it will cause damage to the coating.
We recommend placing all accessories inside the grill and running it on GRILL, temp set to HI
for 20 minutes without adding food. This removes any residues. This is completely safe and not
detrimental to the performance of the grill.
Continue following instructions on page 52 before attempting to do this.
50 ninjakitchen.eu
C
B
E
D
G
ORANGE LIGHT = ON
J
K
I_OG700Series_Parts_PelletScoop.eps
M
BEFORE FIRST USE - CONTINUED
Where to locate the grill
Place grill on a stable and level surface. It is
important this can support the weight and size of
the unit. The underside stays cool and so you can
place the unit on any surface. Position the unit at
least 90cm (3 feet) from walls or anything over
head due to heat and smoke output.
Use in any weather
This grill is safe to use in any weather. The main
unit is IPX4 rated and the plug is IP66. The RCD
plug provides additional protection and it is
designed to trip should there be any issue with
the circuit. When not in use we advise you cover
the unit to keep it looking it's best. Whilst the unit
is safe it will show signs of weathering if exposed
to the elements.
EXTENSION CORD
If using an extension cord, ensure it is suitable for
use outdoors with outdoor appliances. Using the
incorrect cord could lead to the cord overheating,
melting and/or a drop in voltage. A drop in voltage
can increase preheat times and impact cooking
performance and/or cook times.
POWERING THE GRILL
1 Plug the RCD into electrical socket. Switch socket on.
2 Press RESET button on the RCD. The circle above
the RESET button should be illuminated orange. If
this isn't the case, try a different socket. Note: It may
be difficult to see the orange if in direct sunlight.
3 Press the TEST button on the RCD. The circle should
now show black. This means the RCD is functioning
correctly. If pressing the TEST button does not
change the circle to black then contact customer
services.
4 After establishing if the RCD is functioning correctly
once again press RESET. The orange illumination
should re-appear. The unit can now be switched on.
NOTE: RCD Light;
ORANGE = RCD is ON ; BLACK = RCD is OFF
5 Press the ON/OFF switch on the back of the control
panel. Switch is on when the side with the line is
pressed down.
6 Now turn the dial on the front of the control panel
and turn it to the desired function. The display
should illuminate to reveal times or temps. The grill is
now ready to use.
NOTE: The RESET button on the RCD will need
to be pressed every time the unit is unplugged or
the socket switched off.
ninjakitchen.eu 51