Publicidad
TROUBLESHOOTING
GUIDE
If this unit does not seem to operate
properly,
after rereading
the
instructions, check the POSSIBLE CAUSES below.
SYMPTOM
No
power
The playback picture
is noisy.
Pictures are recorded
in black and white.
No playback picture
Noisy or no TV re-
cer)tion
Tape operation
but-
tons do not work, even
though the power is
cm and a tape is loa-
ded.
Abnormal operation
No remote
control
or3eration
POSSIBLE
CAUSES
'" —.
The power cord is not connected.
The unit is in the timer standbv mode.
The TV is not set to the video channel.
The TV is not fine-tuned correctly.
The tracking is not adjustecl.
The video heads are dirty and need tc] be
cleaned.
The connections have not been made tightly.
The COLOR SY!3TEM is set to an incorrect
position. (See page 30,)
The TV is not set to the video channel.
Select the OUTPIJTSYSTEMcorresponding
to the color system of the connected TV.
———
Connections
for antenna, 7-V, and this unit
are not correct.
_——
Moisture
may have condensed
inside the
unit. See "NOTE
ON CONDENSATION"
below.
External interference has affected the internal
microprocessor. Unplug the power cord from
the wall outlet. Then plug it in again.
—
The batteries need to be replaced.
CLEANING THE VIDEO HEADS
Although this unit is equipped with an automatic heacl cleaner, dirt may
accumulate on the video heads after long periods of use. If the pla!/back
picture is blurred or noisy, while the TV programs received are clear, the
heads may bedirly. Inthiscase, clean the video heads using a commercially
available video head cleaning tape.
CLEANING THE UNIT
When the cabinet has become dirty or stained, dip a piece of gauze or soft
cloth into a dilute solution of neutral cleanser, and wipe clean. Never use
thinners or benzine since they will damage the cabinat surface.
MAINTENANCE
1 To maintain
the optimum
performance
of this video unit, regular
periodic maintenance
is required. Your dealer can advise you further.
2
Maintenance
and adjustments
should not be done by the user. In all
cases of difficulty or doubt, consult your dealer.
NOTE ON CONDENSATION
Moisture may condense inside the unit when it is moved from a cold place
to a warm place, after heating a cold room, or under conditions of high
humidity. If the tape is played back under these conditions, the unit and
the tape may be damaged, Do not use the unit until it has warmed to roonn
temperature
and the moisture
has evaporated
completely
in a well-
ventilated area.
Wait about 2 hours, and normal operation should be possible.
72
Publicidad
