Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY WARNINGS
ACCIDENTAL SPILLS
R290
TN and BT models
with integrated unit
Keep unprotected persons away and evacuate them to safe areas.
Immediately ventilate the area following the local safety plan.
Do not touch or inhale the leaked gas.
Disconnect the power cord of the equipment from which the gas is escaping.
For the management of spills, wear suitable respiratory protection devices with air
reserve, gloves and protective goggles. Avoid the inhalation of vapours. Atmospheric
concentrations must be kept to a minimum and kept to the minimum reasonably possi-
ble level, below the occupational exposure limit.
Vapours are heavier than air and therefore high concentrations could form near the ground
where general ventilation is poor.
Avoid contact with naked flames and hot surfaces because irritating and toxic decomposition
products may form or, in the case of flammable gases (R290), explosions and fires.
Disposal of the leaked gas must be carried out by authorised and qualified centres.
If in doubt, contact the local authorities for additional information.
When the emergency is over, contact the technical assistance for repair of the machine.
R290
TN and BT models
with integrated unit
Minor leaks: do not attempt to
stop the gas leak.
Leaks of significant magnitude:
contain spilled material with
sand, soil or other suitable
absorbent material. Prevent
liquid from entering drains,
sewers,
basements
working
holes
the vapours can create a
suffocating atmosphere.
Consider that R290 gas is
highly flammable.
DISPOSAL
R290
TN and BT models
with integrated unit
It is strictly forbidden to discharge this refrigerant into the atmosphere which must be properly
recovered, treated or disposed of following the legal procedures, using qualified and enabled
personnel. If in doubt, contact the local authorities for additional information. The best solution
is to recover and recycle the product: if this is not possible, destruction must take place at
an authorised plant equipped to absorb and neutralise acid gases and other toxic processing
products.
Rev. 0
with remote unit
with remote unit
Minor leaks: if the conditions are sufÏciently safe and there is
adequate ventilation, isolate the source of the leak and allow
the material to evaporate safely.
Leaks of significant magnitude: contain spilled material with
sand, soil or other suitable absorbent material. Prevent liquid
from entering drains, sewers, basements and working holes
because the vapours can create a suffocating atmosphere.
and
because
with remote unit
R452a
BT models
R452a
BT models
R452a
BT models
40
R134a
TN models
with remote unit
R134a
TN models
with remote unit
R134a
TN models
with remote unit
Publicidad
