MAINTENANCE
DISPOSAL AND END OF SERVICE LIFE
The defrosting operations of the electrical and hydraulic circuits must be carried out exclusively by qualified technicians.
If present, remove them and dispose them off in a correct manner:
• Refrigerant gas
• Unfreezeable solutions present in hydraulic circuits, avoiding spills or leaks in the environment.
According to art.13 of Legislative Decree no. 49 of 2014 "Application of Directive RAEE 2012/19/EU on residues of electrical and
electronic equipment"
The mark with stripes on the stripped dumpster specifies that the product was placed on the market after August 13,
2015, and that, at the end of its service life, must not be mixed with other residues, but disposed off separately.
The whole equipment was built with recyclable metallic materials (stainless steel, iron, aluminium, zinc-coated plates,
copper, etc.) in percentage above 90% of the weight.
Render the equipment unusable when disposing off by removing the power source cable and any other device that closes the
compartments or cavities (where present).
Care must be taken in the management of this product at the end of its service life, to mitigate negative impacts on the
environment and improve the effectiveness of the use of resources, applying the principles of "who pollutes pays", prevention,
preparation for re-utilisation, recycling and recovery.
We remind that the uncontrolled or incorrect disposal of the product is liable to the application of the sanctions foreseen in the
present legal standards.
INFORMATION ABOUT DISPOSAL IN ITALY
In Italy, WEEE equipment must be delivered:
• To Collection Centres (also called ecological islands or ecological platforms)
• To the dealer where the new appliance was purchased, which is required to receive it free of charge (on a "one for one" basis).
INFORMATION ABOUT DISPOSAL IN THE EUROPEAN UNION NATIONS
The community Directive on RAEE equipment was accepted in different ways by each nation, therefore, if this equipment must
be disposed off, we suggest a contact with the local authorities or the Dealers about the correct disposal method.
Pending dismantling and disposal, the equipment can also be provisionally stored outdoors, provided that the unit has the
electrical, refrigerating and hydraulic circuits intact and closed. However, make sure that the doors cannot be closed to avoid
entrapment.
The laws in force in the user's country concerning environment protection must also be observed.
WARRANTY
The manufacturer's obligation regarding the warranty that covers the equipment and other parts produced by it is valid for a
period of 1 year as of the invoice date, and consists of the supply free of charge of parts that must be replaced that, at its own
discretion, are considered defective.
It will be the manufacturer's duty to solve eventual faults and defects, provided the equipment is correctly installed and operated
in accordance with the instructions contained in the manual. Any damage arising from limescale build-up, over voltage or
tampering by unauthorised or unqualified personnel will void the warranty.
Consumption components such as glass, aesthetic parts, seals, lamps and parts that subject to wear after utilisation, are excluded
from the warranty.
During the warranty period, the expenses concerning providing of services, travels or transfers, transport of parts and eventual
replacement equipment are borne by the purchaser.
The materials replaced under warranty will remain our property and must be returned at the purchaser's care and expense.
55
USE AND MAINTENANCE mod. PAPRIKA | Rev. 0