Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE WELL, BASKET SUPPORT AND ACCESSORIES
To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool
(see page 9).
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Remove the basket support (A) and clean it.
4 - Drain and filter the oil (see page 10).
5 - Apply a food-grade detergent to the inside of
the well.
6 - Rinse the well with drinking water and drain.
7 - Apply a specific product or a water and vinegar
solution to the well to remove the detergent res-
idues.
8 - Rinse, empty and dry the well.
9 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
TROUBLESHOOTING
The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
Fault
The heating elements do not
come on
The appliance does not heat up to
the set temperature
The control panel does
not come on
FAULT
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Cause
Electrical connection not made
correctly
Safety thermostat tripped
Contactor not receiving electrical
power or faulty
Electronic circuit board not receiv-
ing electrical power
- 13 -
A
IDM-39611801000.tif
Remedy
Check the connection of the elec-
trical wires
Carry out the appliance reset
(see page 11)
Check the condition of the ther-
mostat and activate any ignition
enabling device
Check or replace the contactor
coil
Check or swap the phase wire
connections
6
IT
GB
DE
FR
ES
English
Publicidad
