Cleaning process:
1. Make sure that the appliance is disconnected from the mains and the steam
regulator is in position.
2. Fill the water tank with 1 liter of the prepared descaling solution, in
accordance with the instructions from the descaling agent. Or you can use a
weak solution of citric acid with water (10 g per 1 liter of water)
3. To clean the steam supply tube, follow the steps from the HOT WATER
section to run the solution through the steam supply system. (200-300 ml)
4. To clear the main system of scale, do 2-3 times the process of making coffee
for 2 cups. Attention: No need to use a coffee filter and add coffee to the filter.
It is necessary that the solution passes through the main internal system
(700-800 ml).
5. After you have done the descaling solution, it is necessary to rinse the
internal system with clean water. To do this, wash the water tank, add clean
water to the tank and repeat steps 3 and 4.
6. Cleaning is complete.
Before the first use, it is necessary to flush the main system
and the steam supply system, for this you need to do the
following:
1. Pour water into the tank, the water level should not exceed the "MAX" mark in
the tank.
2. Use the joystick to select the hot water supply function to flush the
PANARELLO steam nozzle. The removable part of the nozzle can be rinsed
under hot water.
3. Select the 2-cup coffee preparation mode to flush the main system. Attention:
No need to use a coffee filter and add coffee to the filter.
4. Cleaning is complete.
When pumping water from the tank into the boiler, extraneous noise may be
heard. It is ok.
27
- 27 -