V2 NUUR4 Manual De Instrucciones página 56

3.8 - INSTALLING THE BOOM
Proceed as follows to mount the boom of the gate:
1. solo per NUUR6: insert the aluminium connector (D) into one end
of the shortest boom and lock it with the screw provided
16
D
2. only for booms made up of two pieces: connect the universal
joint (E) into the free ends of the two booms, aligning the holes
correctly; loosen the three screws of the joint equally so that the
latter can be fastened inside the booms
17
E
m
ATTENTION: if boom lights must be installed, proceed
before assembling the bumper rubber.
For installation of the lights, refer to chapter 15.3
- 54 - ENGLISH
E
3. lightly oil the aluminium rail on both sides
4. along the entire length of the boom, insert the rubber impact
protectors through the slots (F) alternating them with the relevant
joints (G); the rubber protector can protrude roughly 1 cm from
the end of the boom
18
F
G
5. put on the boom cap (H) and secure it with the two screws
6. position and fit together the two rubber protector caps (I)
19
NUUR6
NUUR4
H
I
F
G
F
H
I
Ø3.5 mm
F
F