V2 NUUR4 Manual De Instrucciones página 76

15 - FURTHER INFORMATION
(Accessories)
15.1 - PLUG IN RECEIVER
KB24 control unit is suitable for plugging in MR receiver.
33
m
WARNING: Pay attention to the way you connect the
removable modules.
MR module receiver is provided with 4 channels and each of
them is suitable for a command of KB24 control unit:
g
• CHANNEL 1 START1
g
• CHANNEL 2 START2
g
• CHANNEL 3 STOP
g
• CHANNEL 4 COURTESY LIGHT
NOTE: Before programming 4 channels and function logics
read carefully the instructions of MR.
15.2 - CONNECTING AND INSTALLING THE
BACKUP BATTERY
c
The electrical connection of the battery to the control
unit must be made only after completing all the installation
and programming stages, as the battery is an emergency
power supply.
c
Before installing a back-up battery, disconnect the
power supply to the control unit.
To install and connect the battery:
1. install the battery holding bracket
2. position the battery on the bracket and fasten it with the tie
- 74 - ENGLISH
34
BATTERY
3. connect the battery to the dedicated connector
15.3 - BOOM LIGHTS CONNECTION
(OPTIONAL ACCESSORY)
For installation:
1. bring the boom to the vertical position
2. unscrew the screws fastening the barrier cover and the support
3. temporarily remove the boom
35