V2 NUUR4 Manual De Instrucciones página 67

-Cnt
13 - PROGRAMMING THE CONTROL UNIT
-PrG
The configuration menu
display shows the selected item.
i
By pressing , you will pass to the next item; by pressing
to the previous item.
By pressing OK, you can view the current value of selected item and
possibly change it.
FinE
The last menu item ( ) allows storing the carried out changes and going
back to the control unit normal operation. You must exit from programming
mode through this menu item if you do not want to lose your configuration.
m
WARNING: in case no operation is carried out for more than
one minute, the control unit exits from the programming mode
without saving any of your setups and changes, which will get lost.
i h
By holding down the or
FinE En.SA
until item or is viewed.
In this way, you can quickly reach either the top or bottom of the list.
EvEn
ESC
tot
SEru
2
consists in a list of configurable items; the
keys, configuration menu items will scroll fast,
0 12.
.45 1
1
-01.3
h
, you will return
-PrG
n 1
4
20-8
14.14
.19
E176
ESC
-03.3
-02.3
-02.2
3
FinE
En.SA
dir
ENGLISH - 65 -