Publicidad
ENGLISH
WARNING: Before it is put into servi-
ce, the system must be tested to check the
operating conditions of every single compo-
nent and identify any malfunctions. In this
stage, it is important to check that all health
and safety requirements have been com-
plied with in full.
To test the system, make the following checks:
Check that the mains voltage is the same as
)
that of the appliance.
INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS
The appliance's main functions do not require
any special adjustments by specialist staff ex-
cept the settings made during use by the user.
INSTRUCTIONS AND WARNINGS FOR PART REPLACEMENT
The appliance does not require the replace-
ment of operating components by specialist
staff except the replacement of standard parts
which can be carried out by the user.
APPLIANCE DECOMMISSIONING, SCRAPPING AND DISPOSAL
NOTE
: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during decom-
missioning.
When decommissioning the appliance, a set
of procedures should be carried out to ensure
that the appliance and its components are not
a hindrance and are not easily accessible.
To prevent the appliance from posing risks to
people or the environment, disconnect and
disable all energy sources (electricity, etc.), and
drain any liquids (lubricants, oils, etc.).
12
TESTING OF THE APPLIANCE
ADJUSTMENTS
REPLACING PARTS
Operate the appliance's circuit-breaker to
)
check the electrical connection.
Check that the safety device is operating cor-
)
rectly.
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance
into operation in conditions of safety, in accor-
dance with legal requirements.
Place the appliance in a suitable and not easily
accessible area, with barriers to prevent anyone
from accessing it.
When scrapping, sort all components by chem-
ical characteristics and dispose of them sepa-
rately in accordance with the relevant applica-
ble laws.
IMPORTANT: Never dump non-bio-
degradable materials, lubricating oils and
non-ferrous metal components (rubber, PVC,
etc.) in the environment. Dispose of them in
accordance with the applicable laws.
ADJUSTMENTS
3326541_inst_GB_rev.1
Publicidad
