Publicidad
FAULT
The appliance has been tested before being
put into service. The information provided
below is intended to assist in the identifi
cation and correction of any anomalies and
malfunctions which might occur during use.
The user can solve some of these problems
himself, but for others specifi c technical
knowledge or skill is required, and so they
Faults
The plates do not turn
on
The plates do not turn
off
The heating elements
do not come on
The appliance does
not heat up to the set
temperature
3326541_ut_GB_rev.1
FAULT
TROUBLESHOOTING
must only be carried out by qualifi ed staff
with recognised experience acquired in the
specifi c sector of operation.
agents or headquarters, which can be
found in the contacts section of the website
www.angelopo.com.
Causes
Electrical connection not
made correctly
Safety thermostat tripped
Switch faulty
Component fault
Electrical connection not
made correctly
Safety thermostat tripped
Switch faulty
Thermostat faulty
NOTE:
For any need, please contact Angelo Po's
Check the connection of the
electrical wires.
NOTE: Contact the after-
sales service.
Wait for the thermostat to
automatically reset appliance
operation (this takes around 30
NOTE: Contact the after-
sales service.
Replace the switch.
NOTE: Contact the after-
sales service.
NOTE: Contact the after-
sales service.
Check the connection of the
electrical wires.
NOTE: Contact the after-
sales service.
Carry out the appliance.
NOTE: Contact the after-
sales service.
Replace the switch.
NOTE: Contact the after-
sales service.
Replace the thermostat.
NOTE: Contact the after-
sales service.
ENGLISH
Remedies
minutes).
23
Publicidad
