Angelo Po 0N0FAA Manual De Uso página 141

HANDLING AND INSTALLATION
All installation stages must be considered right
from production of the general layout. Before
starting these stages, as well as deciding the
place of installation, if necessary, the person au-
thorised to carry out these operations must orga-
nise a "safety plan" to protect the people directly
involved, as well as ensure strict compliance with
all legal requirements, especially those relating
to mobile work-sites.
The place of installation must be provided with
all the connections needed to supply the appli-
ance and dispose of the production residues.
It must be suitably lit and must meet all legal
health and hygiene requirements to prevent any
food contamination.
If necessary, fi nd the exact position of each in-
dividual appliance or subassembly and mark the
coordinates to place them correctly (see explan-
atory diagram).
IMPORTANT:The unit is not suitable
for built-in installation.
WARNING: Do not install the unit next
to walls made of fl ammable material.
WARNING: Air inlets are required in
the room where the appliance is installed to
ensure a proper operation of the appliance
and to exchange the air in the room.
WARNING: The air inlets should be of
appropriate size, protected by gratings, and
placed so that they cannot be obstructed.
3319961_inst_GB_rev.1
INSTALLATION OF THE APPLIANCE
ROOM VENTILATION
WARNING: Do not install the unit on
uneven, soft or sloped fl oors.
WARNING: Leave a gap of at least 5 cm
from the wall when installing the appliance.
Install in accordance with the relevant legisla-
tion, regulations and specifi cations in the coun-
try of use..
ENGLISH
9