Publicidad
Idiomas disponibles
Idiomas disponibles
USE AND OPERATION
INSTRUCTIONS AND WARNINGS FOR USE AND OPERATION
NOTE: Carefully read the hazards men-
tioned in section "Hazards and safety provi-
sions during use" on page 8.
ATTENTION: Besides being autho-
rised and appropriately documented, and if
necessary, instructed and trained, on fi rst us-
age, users shall simulate several operations to
identify the controls and main functions.
WARNING: Use only as intended by the
manufacturer and never tamper with any de-
vice to obtain performance levels outside the
rated specifi cations.
ATTENTION: Before use, check that
the safety devices are properly installed and
in good working order.
ATTENTION: As well as taking care to
meet these requirements, users should also
implement all safety regulations and read the
description of the controls and the start-up
procedure carefully.
Burner control knob: controls the supply of
A)
gas to the burner.
Front burner
A
A
Minimum power
marker
3319961_ut_GB_rev.1
USE AND OPERATION
DESCRIPTION OF CONTROLS
marker
Full power
marker
WARNING: The fl oor near the appli-
ance could be slippery.
WARNING: Do not obstruct the fl ue to
prevent the temperature of the combustion
components and products from increasing
excessively over the admissible limits.
To ensure correct use of the appliance, the fol-
lowing rules should be adopted.
– Use only the accessories recommended by the
manufacturer.
– Always keep the appliance and the surround-
ing areas clean.
– When cleaning, use only food-approved deter-
gents.
WARNING: Use PPE to prevent scald-
ing from contact or hot food boiling over.
IMPORTANT: The 7 kW burner requi-
res pans with a diameter of min 200 mm and
max 420 mm; the 10 kW burner requires pans
of min. 240 mm and max 460 (500 mm only
for burners working individually); the 4 kW
burner requires pans with a diameter of min
140 mm and max 320 mm.
Pilot light
Off
marker
marker
A
A
ENGLISH
Rear burner
marker
A
17
Publicidad
