Publicidad
Idiomas disponibles
Idiomas disponibles
FAULT
Carefully clean all the connecting parts be-
7)
tween the burner cap (A) and the burner (B). If
necessary use a steel wire brush for mechanics
Clean every part of the hob with a suitable de-
8)
greaser.
Dry the surfaces and reassemble the parts.
9)
For the correct assembly of the burner (B) and
burner cap (A), follow the directions given in
the illustration.
Turn on the burners for a few minutes to en-
10)
sure a thorough drying and thus avoiding the
formation of rust.
The appliance has been tested before being put
into service. The information provided below
is intended to assist in the identifi cation and
correction of any anomalies and malfunctions
which might occur during use.
The user can solve some of these problems him-
self, but for others specifi c technical knowledge
or skill is required, and so they must only be car-
Faults
Smell of gas
The pilot light does not
ignite
The pilot light goes out
The fl ame is yellow
Burner control knob is stiff
3319961_ut_GB_rev.1
parts such as the burners, burner caps and
grids in a dishwasher.
dirt to fall into the burner as this will cause a
fault in the burner or block the nozzle.
FAULT
TROUBLESHOOTING
ried out by qualifi ed staff with recognised experi-
ence acquired in the specifi c sector of operation.
Angelo Po's agents or headquarters, which
can be found in the contacts section of the
website www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
Air in pipelines due to long
period out of use.
The thermocouple has not
warmed up enough.
Burner dirty
Gas control valve
malfunction.
WARNING:
Do not wash cast iron
WARNING: Never pour water or allow
NOTE
: For any need, please contact
Remedies
Turn off the gas supply tap and
ventilate the room.
Make more attempts
to light the fl ame.
Make more attempts to light
the fl ame.
Clean the burner
NOTE: Contact the
after-sales service.
ENGLISH
21
Publicidad
