Angelo Po 0N0FAA Manual De Uso página 146

ENGLISH
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screw (D).
4)
Set the burner mount (E) at a distance of 20
5)
mm. and tighten the screw (D).
Replace the control panel (B) and the knob (A)
6)
on completion of the operation.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screw (D).
4)
Set the burner mount (E) at a distance of 20
5)
mm. and tighten the screw (D).
Replace the control panel (B) and the knob (A)
6)
on completion of the operation.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screws (D) and extract the cap (E).
4)
Pull off the cone (F).
5)
Clean the cone (F) and its seat.
6)
Coat the cone with grease (F), fi t it in its seat
7)
and turn it a few times.
Pull off the cone (F) to remove the excess
8)
grease.
Replace the cone (F) and the cap (E).
9)
Replace the control panel (B) and the knobs
10)
(A) on completion of the operation.
14
ADJUSTING TOP BURNER PRIMARY AIR (7 KW)
ADJUSTING TOP BURNER PRIMARY AIR (10 KW)
GREASING THE GAS TAP
A
C
B
A
C
B
A
C
B
NOTE: We recommend gas STABURA-
GAS N32 by KLÜBER LUBRICATION ITALIA
S.A.S.
ADJUSTMENTS
C
C
E
F
C
D
3319961_inst_GB_rev.1
D
D