Publicidad
Idiomas disponibles
Idiomas disponibles
in your home is suitable to install this
appliance.
• See image 02 on page 5 to visualize the
electrical connections.
• UniversalBlue
accountable
installations (not described in this
manual) or carried out by non-qualified
personnel
• The manufacturer will not be held
accountable for any damage caused by
an incorrect installation.
• Remove all protective sheets and
adhesive tape before using it for the
first time.
Rememeber that the hob must
not be sealed with silicone. The
warranty will no longer be
valid if this happens.
• The installation surface must be flat
and levelled, and no other structural
part must interfere in the space
requirements.
• Keep
the
mínimum
described in the following images
• Image 03 on page 5
• Image 05 on page 6
• Image 07 on page 7
• Image 08 on page 7
• The material of the installation surface
must be heat resistant.
• If the cooking hob is installed on top
of an oven, make sure the oven has a
cooling fan incorporated.
• The installation must comply with all
legal requirements, regulations and
applicable laws.
• There must be an isolator switch in
the final installation that allows total
disconnection from the main power
supply, installed and located so that
it
complies
with
concerning electrical installatios.
• This switch must be certified and there
must be a 3 mm isolating distance
between all the poles (or between all the
conductors if the pertinent regulations
concerning
electrical
allows this change)
will
not
be
held
for
inappropriate
distances
the
regulations
installation
• The disconnect switch must be easily
accessible to the end user after the
installation.
• Check with your local authorities if you
have any doubt about the installation
• Use materials which are heat resistant
and easy to clean (for example, tiles) for
the finishings around the hob.
Installation (see image 04 on page 6)
• Turn the hob upside down and place it
on a soft and smooth surface.
• In order to prevent any substance or
liquid from getting between the hob
and the counter, put the adhesive
tape included in the package on the
perimeter of the bottom part of the hob,
it will act as a sealant. Be careful when
you put it in the corners and avoid
any empty spaces (it must be evenly
applied)
• Putt he hob on the counter with the help
of the clamp and the screws supplied.
• If the hob has been installed above
a drawer there must be a separating
as
wooden sheet to prevent the bottom
part of the appliance from touching
anything in the drawer (see image 05
on page 6)
• If the hob is going to be installed in a
cabinet, as described in the previous
picture, there must be a wooden sheet
between the cabinet and the hob. If
there´s going to be a built-in oven, you
can skip this part.
• If the hob is going to be installed next to
a wall, the minimum distance between
the wall and the hob must be at least 50
mm, left or right.
• Make sure that the hob is always well
ventilated, and that the air inlet and
outlet are not blocked. Make sure that
the hob is functioning normally, as
described below (see image 32 on page
8).
After installing the hob, make sure that
• There is no access to the power cord
from the cabinet doors or drawers;
• There is enough fresh air flow from the
outside of the cabinet to the bottom part
EN
37
Publicidad
