AL-KO AMS2 Mammut Tandem Manual De Instrucciones página 34

en
Malfunction
The system does not establish a
radio link (operation LED on the
remote control does not show
continuous green after a positio-
ning attempt)
The system establishes a radio
link, but the drives cannot be
moved to the wheels
Manoeuvring does not work
(operation LED continuously
green, drives in position, no red
LED on the remote control)
During performance of one of
the functions positioning, ma-
noeuvring, retracting, the move-
ment is unexpectedly interrupted
Drive retraction does not func-
tion
Manoeuvring does not function
correctly. Caravan does not re-
act as required, or not at all.
34
Possible cause
No initial start-up performed
Error during initial start-up
No teach-in of new remote con-
trol
Release line defective
Plug connections of the supply
cable disconnected or defective
(e.g. 3-pin plug)
System defective
System defective
Poor radio link or interruption in
connection
System defective
Error during initial start-up
Remote control in wrong opera-
ting mode
Solution
Repeat initial start-up
Fit a new release line. (As a
temporary solution, the release
button on the F-C-A can be
used for releasing the system)
Check plug connections and
connect all plugs together. Con-
tact an AL-KO service centre if
the plug connections are defec-
tive.
Check the LED on the remote
control. If the operation LED
lights up red: Contact an AL-KO
service centre
Contact an AL-KO service
centre
Reduce the range from the dri-
ves, but keep a minimum dis-
tance of 0.5 m
With the retract key pressed,
hold the remote control on the
release switch – drives are re-
tracted. Repeat the procedure
once if necessary. If this does
not work: Retract the drives ma-
nually
Repeat initial start-up
Press keys d and g simulta-
neously if the "maximum grade-
ability" LED lights up in teach-in
mode. The LED goes out
694 570_e