Disengaging The Drives From The Wheels; Hitching Up The Caravan - AL-KO AMS2 Mammut Tandem Manual De Instrucciones

Ocultar thumbs Ver también para AMS2 Mammut Tandem:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 80
en
5. Once the caravan is in the required position, apply the caravan's handbrake.
CAUTION!
The caravan may make a slight rocking movement when the drives are retracted, depending
on the last manoeuvre and the resulting stresses in the axles.
6. Move the drives away from the wheels.
Do not park the caravan with its axles stressed/locked up.
After performing tight cornering manoeuvres or pivoting on the spot, move the caravan
in a straight line forwards or backwards for at least 1 metre.
7. Hold the keys pressed (fig. 2 d, e, f and g) until the LEDs on the retract keys are flashing and the
operating status LED is continuously lit. Only then are all drives completely retracted.
8. Check whether the drives are correctly retracted.
9. Switch the remote control off at the master switch.

Disengaging the drives from the wheels

CAUTION!
Risk of accident due to trailer rolling away!
Always apply the handbrake of the caravan before starting to disengage the drives.
The numbers in brackets refer in this section to Fig. 2.
1. 1. Press and hold both Reset buttons (d and e) until their LEDs start to flash.
The process is activated; you can now release the buttons.
The drives retract away from the wheels. If both LED's light up continuously, the drives are fully
retracted.
2. Wait until the operating state LED also flashes.
The drives are safely switched off only when the operating state LED flashes, and this will not
lead to a system lock.
3. Switch off the remote control at the ON/OFF switch (b) located on the side.
4. Check that both drives are correctly disengaged.
If the drives were not completely disengaged (radio contact interrupted or remote control swit-
ched off too soon), the following steps must be carried out:
Hold the remote control against the enabling switch while pressing the Reset buttons (d
and e).
Now perform the steps under Disengaging the drives from the wheels again.

Hitching up the caravan

When you want to hitch up your caravan, you can use the AL-KO Mammut to manoeuvre the caravan
directly over the tow hitch.
1. Manoeuvre your caravan over the trailer coupling of your vehicle.
2. Correctly couple the caravan.
3. Apply the handbrake on the caravan.
4. Then disengage the drives from the wheels.
The distance between the drive and the wheel must be at least 20 mm.
If the distance is smaller and/or if the drives cannot be moved off the wheels, the drives must
be retracted manually.
Remove the fuse and disconnect the battery!
32
694 570_e

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ams2

Tabla de contenido