Pairing The Remote Control And The System - AL-KO AMS2 Mammut Tandem Manual De Instrucciones

Ocultar thumbs Ver también para AMS2 Mammut Tandem:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 80
en
We recommend having all installation work carried out only by competent specialist workshops
or our AL-KO Service Centres.
Installation
Comply with the safety and warning information in the installation instructions.
System
CAUTION!
Risk of injury!
No one is allowed to be in the caravan or within the turning circle during manoeuvring.
The manual retraction is not allowed to be used for positioning the drives on the wheels.
AL-KO Mammut is not allowed to be operated on unbraked caravans.
AL-KO Mammut is only allowed to be used by adults.
Radio remote control
CAUTION!
Danger due to inadvertent operation!
Do not plug in or put down the remote control when it is in operational status. You could inad-
vertently perform a movement using the joystick.
Before switching on the remote control for the first time, refer to the section "Initial start-
up".
Keep the remote control away from unauthorised people.
Do not place any objects on the remote control.
Protect the remote control against moisture and contamination.
There can be isolated interruptions during the manoeuvring procedure as a result of external
influences (e.g. powerful radio transmitters).

Pairing the remote control and the system

This step involves transferring the identification of the remote control to the drive controller. The joystick
is calibrated at the same time.
The remote control must be switched off and the system in active.
The numbers in brackets in this section refer to figure 2.
Carry out points 2 to 10 within 10 seconds in the caravan with F-C-A (radio CAN adapter)
directly in succession. Do not touch the joystick when doing this. It must be in the central
position to avoid malfunctions.
1. Insert the batteries into the battery compartment of the radio remote control.
Make sure the polarity is correct,
2. Press keys (e and f) simultaneously on the remote control [teach-in mode] and hold them both pres-
sed.
3. Switch on the remote control at the master switch (b) whilst holding the keys pressed.
4. Release keys (e and f).
All LEDs light up briefly one after another.
After this, the LED for the operating status starts to flash red, the LEDs for the maximum drive
temperature and maximum gradeability are continuously lit.
Press keys d and g simultaneously if both LEDs do not light up continuously.
The remote control is now in tandem mode.
36
694 570_e

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ams2

Tabla de contenido