Starting / Stopping The Engine - Stihl FS 460 C-M Manual De Instrucciones

Putting down the machine in an
emergency
WARNING
As soon as it becomes apparent that a
dangerous situation is developing, the
machine must be put down quickly.
Practice setting down the machine
quickly. In order to avoid damage, when
practicing, do not throw the machine on
the ground.
FS 460 C-M, FS 460 C-M L, FS 490 C-M, FS 490 C-M L
Starting / Stopping the
Engine
Controls
3
2
1
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop
positions. Press the momentary
contact stop switch to switch off the
ignition.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position, i.e. when it is not depressed:
The ignition is switched on – the engine
is ready to start. Operate the stop switch
to switch off the ignition. The ignition is
switched on again automatically after
the engine stops.
Symbols on choke knob
FS 490 FS 460
FS 360, 410, 460
Run position F – a hot engine is started
in this position or the engine runs in this
position.
Start position } – a cold engine is
started in this position.
Starting the Engine
FS 360, 410, 460
4
FS 490
4
Press the manual fuel pump
N
bulb (4) at least five times – even if
the bulb is filled with fuel.
English
31