Publicidad
Idiomas disponibles
Idiomas disponibles
How to Use
EN
Vacuum and Mop
Note: When using the mop assembly for the first time, the robot performs the
"Vacuum and Mop" task by default.
1. Start cleaning
Press the button
on the robot, or use the app to make the robot start from the
base station. Then the robot will plan the optimal cleaning route and perform
the cleaning task based on the created map.
Note:
·The mop pads will be cleaned before the robot starts mopping, please wait
patiently.
·Do not move the base station, the clean water tank, the used water tank, or
the washboard during its working.
·Hot water cleaning can be enabled in the app for mop pad and base station
cleaning tasks, which applies to all modes. To prevent scalding, do not
touch the water outlet of the washboard when the function is on.
14
2. Auto mop washing
When cleaning, the robot will automatically return to the base station to wash
mop pads based on the mop pad cleaning frequency specified in the app. The
base station will automatically refill the robot's water tank and the robot will
resume cleanup.
Note: If the robot returns to the base station to wash its mop pads during
cleaning, the base station will not automatically empty the dust box.
How to Use
3. Automatically empty the dust box and wash and dry the mop pads after
finishing the "Vacuum and Mop" task
After the robot finishes a cleaning task and returns to the base station to charge,
the base station will automatically start emptying the dust box, and then clean
and dry the mop pads.
Note:
·If the auto-empty function is turned off in the app, the base station will not
automatically empty the dust box.
·The base station will empty the dust box according to the frequency set in
the app.
4. Clean the used water tank
After the robot has completed the task, please clean the used water tank to
avoid any odor.
Vacuum then Mop
Select "Vacuum then Mop" in the app, and the robot will automatically lift the
mop assembly to vacuum the floor. After vacuuming is completed, the robot
will return to empty the dust box, and then start mopping after automatically
lowering the mop assembly.
Vacuum Only
Select "Vacuum Only" in the app and the robot will automatically lift the mop
assembly and start vacuuming.
Mop Only
Select "Mop Only" in the app, and the robot will check if the mop assembly is
installed. If not, manually install the mop assembly, and then the robot will
automatically start mopping.
EN
15
Publicidad
