Dreame DreamBot L10s Pro Ultra Heat Manual Del Usuario página 11

Routine Maintenance
EN
Parts
To keep the robot in good condition, it is recommended to refer to the accessory usage in the app or the following table for routine maintenance.
Replacement
Part Maintenance Frequency
Period
Used Water Tank After each use
Clean Water Tank
Every 6 to 12
Main brush
months
Once every 2 weeks
Dust box's filter
Every 3 to 6
months
Side brush
Washboard
Base station's
signaling area
Base station's
charging contacts
Base station's auto-
empty vent
Once every month
Omnidirectional
wheel
Edge sensor
Laser Distance
Sensor (LDS)
Line laser sensor
16
Part Maintenance Frequency
AI Visual Sensor
/
Carpet Sensor
Cliff Sensors
Robot's charging
contacts
Once every month
Bumper
Robot's auto-empty
vent
Robot's automatic
water refilling inlet
Bottom of the robot
Dust box Clean it as needed
/
Dust bag
/
Mop pad
Note: The replacement frequency will depend on your usage of the robot.
If an exception occurs due to special circumstances, the parts should be
replaced.
Routine Maintenance
Base Station Cleaning
1. Select "Base Station Cleaning" in the app, and the robot will exit the base
station automatically. Take out the washboard and wait for water to fill the
Replacement
bottom of the base station.
Period
/
2. Rinse the washboard with clean water, and use the cleaning tool to clean
the bottom of the base station.
6-8 weeks
Every 1 to 3
months
3. After a moment, the base station will automatically pump out the used
water. Then dry it with a soft and dry cloth, and put the washboard back into
place.
4. Use the app or briefly press the button on the robot to make it return to
the base station.
Note: During cleaning, do not make the robot return to the base station.
EN
17