Publicidad
Idiomas disponibles
Idiomas disponibles
Routine Maintenance
EN
Side Brush
Remove and clean the side brush.
Omnidirectional Wheel
Note:
·Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
·Rinse the omnidirectional wheel under the running water and put it back
after drying it completely.
20
Dust Box and Filter
1. Open the robot cover and press the dust box clip to remove the dust box.
Then remove the filter and tap its basket gently.
Note: Do not attempt to clean the filter with a brush, a finger or sharp
objects to prevent damage.
2. Rinse the dust box and filter with water and dry them completely before
reinstalling.
Note:
·Rinse the dust box and filter with clean water only. Do not use any
detergent.
·Use the dust box and filter only when they are completely dry.
Routine Maintenance
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft and dry
cloth, as shown in the below figure:
Laser Distance
Sensor (LDS)
Cliff Sensors
24h
Note: A wet cloth can damage sensitive elements within the robot and the
base station. Please use a dry cloth for cleaning.
Charging Contacts
Clean the charging contacts and the signaling area of the base station with
a soft and dry cloth.
AI Visual Sensor
Line Laser Sensors
Edge Sensor
Bumper
Charging Contacts
Auto-empty Vents
Clean the auto-empty vents of the robot and the base station with a soft and
dry cloth.
Carpet Sensor
EN
21
Publicidad
