Garland 4 en 1 TASKER KEEPER 20Vx2 122-V23 Manual De Instrucciones página 49

the green light will stay fixed, if there is a problem the
green light will flash) then press the security button (2)
and, without releasing it, press the trigger throttle (3).
Disconnection of the machine:
Release the throttle trigger (3), press the on/off button
(1), if you are not going to use it for a long time,
remove the battery.
After turning off the machine, the cutting tool
will continue to rotate for a few moments due
to inertia. Wait until the cutting tool has stopped
before performing maintenance on the machine or
transporting it.
5.3.3. CHECK POINTS AFTER START-UP
It is important to pay attention to possible loose parts
or and the temperature of the machine. If you detect
any anomaly in the machine, stop immediately and
check it carefully.
In the event of any anomaly or problem, take the
machine to the technical service for repair. Under no
circumstances continue to use the machine if it does
not seem to be working properly.
Do not use the machine if it is damaged or
incorrectly adjusted.
5.3.4.- VERIFICATION OF AUTOMATIC LUBRICATION
If you are using the pruning accessory:
After starting the engine, accelerate the
chainsaw until the chain rotates at a
medium speed and check if the
chainsaw oils the chain, for this, it will
be worth observing that when placing
the chainsaw as in the figure at medium speed, oil is
thrown out.
5.4. BATTERY CHARGE
The supply voltage and current must comply with the
indications on the charger's nameplate.
Before using the battery for the first time, charge it for
at least 1 hour.
To charge the battery, plug the charger into the mains,
the led will light up red. Put the battery in the charger,
the led will turn green and start blinking. The charger
LED will turn from flashing green to green when the
battery is fully charged. When the battery is charged,
remove it from the charger. If you leave the battery
in the charger and it is fully charged, the charger will
automatically turn off after 2 hours, the green LED
still on.
The charging time for a fully discharged battery is 2.5
hours.
If you insert the battery into the charger and the
led starts blinking red, it means that your battery is
damaged or that the battery does not correspond to
this charger.
Recharge the battery when you notice that the power
of your machine decreases. Avoid using the machine
until the battery is fully discharged.
Battery charge indicators
49/152
English
Charge button