cecotec DRUMFIT INDOOR 13000 RACE SPRINT Manual De Instrucciones página 27

ENGLISH
24 Handlebar
25 Console
26 Round-head screw
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Indoor bicycle.
Assembly kit
-
- Batteries 2 x AAA
- Instruction manual
3. ASSEMBLY
Before starting assembly, check that no parts are missing. It is highly recommended to
assembly the machine between two people and in an open space.
Step 1. Fig. 2
- Take the machine out of its packaging.
- First, place the front and rear stabilisers on the main frame. Use four screws, four plain
washers and four cap nuts. Secure everything with the spanner.
Step 2. Fig. 3
As shown in figure 3, connect the handlebar stem cable to the one on the main frame. Next,
loosen the adjustment knob and insert the handlebar stem into the main frame. Once this step
has been completed, retighten the knob.
52 DRUMFIT INDOOR 13000 RACE SPRINT
1
1
4
Step 3. Fig. 4
Align the holes on the handlebar with the ones on its stem and fix both parts with four-cylinder
head screws and four plain washers. Use the Allen key to tighten the screws.
Step 4
- Place the handlebar trim. Simply press it and it will snap into place. Fig. 5
- Connect the console cables and place it on its bracket. Fig. 6.
Step 5. Fig. 7
- Take the pedals and remove the pre-fixed nut.
- Put them in the main frame. The left pedal is tightened counterclockwise. Make sure that
you have put each pedal on its corresponding side. The reference (right/left) is taken as if
the user was sitting on the saddle. The left pedal is marked with an "L", the right pedal with
an "R".
- Adjust the pedals in the direction of the arrows shown in figure 7.
Then, replace the previously removed nut and fix it with the large spanner. This step serves
-
to prevent the nut from loosening over time.
Note:
Make sure you have tightened the screws on both pedals with the provided tools. Do not use
the screws before installing the saddle.
Step 6. Fig. 8
Insert the saddle on its post and use the provided spanner to fix it.
4. OPERATION
Getting on and off the bicycle
Before getting on the bicycle, make sure the pedals are properly attached. Stand next to
-
the bike and pass the leg that is closer to it over the frame to sit on the saddle; then, insert
your feet in the pedals.
- To get off the exercise bike, do the previous step in reverse order.
Resistance adjustment. Fig. 9
- To increase resistance, raise the lever upwards.
- To reduce resistance, lower the lever downwards.
Assembling the saddle Fig. 10
- If the saddle is correctly positioned, both the efficiency of movement and comfort will be
improved. It also reduces the risk of injury.
ENGLISH
DRUMFIT INDOOR 13000 RACE SPRINT 53