Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Filling The Reservoir Water
1. Fill the water reservoir with clean tap water to the max
fill line.
Note: The overflow drain prevents overfilling.
To Change Reservoir Water
1. Unplug the saw.
2. Remove the overflow drain and empty waste water
into a bucket. DO NOT allow the water to splash onto
the ground or around the machine.
3. Rinse the machine thoroughly.
Note: Make sure there is no debris inside the water level
component compartment.
4. Discard the waste water in accordance with local
regulations.
5. Replace with clean water.
Locking the Sliding Table
• Align the table lock and slot on the sliding table.
• Tilt the table lock lever outward and push it to left into
the slot to lock.
1
2
21
G
kobalttools.com
Publicidad
