Kobalt KWS B72-06 Manual De Instrucciones página 22

OPERATING INSTRUCTIONS
Unlocking the Sliding Table
• Tilt the table lock lever outward and push it to right to
unlock.
Using the Miter Guide
To adjust angles:
• Loosen the miter knob.
• Rotate to the desired angle by moving the guide left or
right.
• Tighten the knob securely before turning on the saw.
Making Cuts
• ALWAYS draw the line to be cut on the tile using a marker or grease pencil. If the tile is shiny and
hard-to-mark, place masking tape on the tile and mark the tape.
• A common problem when cutting tile is straying from the marked line. Once you've strayed from the
mark, you can not force the wheel back to the line by twisting the tile. Instead, back up and recut the
tile slicing off a small amount of tile until the wheel is back on track.
• To avoid this problem, use the miter guide whenever possible.
• Another problem is cutting difficult material. To prevent chipping of the material at the end of the cut:
first cut 1-1/2 in. of the material, then turn off the saw; flip the material around 180° and make the cut.
• Clean the saw blade, rip and miter guides, and bevel table frequently during use. Debris from the cut
material can interfere with the function of the tool.
22
kobalttools.com