Descargar Imprimir esta página

Kobalt KWS B72-06 Manual De Instrucciones página 26

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
ADJUSTMENTS
WARNING
Before performing any adjustment, make sure the tool is unplugged from the power supply and the
switch is in the OFF position. Failure to heed this warning could result in serious personal injury.
To Adjust Sliding Table Square To Blade
• Unplug the saw.
• Lay a right angle square flat on the blade surface with
one end against the sliding table fence.
• If the blade is not 90° to the sliding table fence, the rail
will need adjustment.
• Loosen the four front and rear screws on the rail base
with 5mm hex key (not supplied), and adjust rail until it
is parallel to the blade.
• Move the rail until the sliding table fence is square to the
blade.
• Tighten the four rail screws.
Right angle
Right angle
square
square
26
Screw
Screw
Screw
Screw
kobalttools.com

Publicidad

loading

Este manual también es adecuado para:

1085049