Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Make a Miter Cut
Miter cuts are used for cutting outside and inside corners
on material, decorative chair rail, and base moulding with
the material at any angle to the wheel other than 90°.
Miter cuts tend to "creep" during cutting. This can
be controlled by holding the workpiece securely against
the miter guide.
• Using a marker or grease pencil, mark the area to be
cut on material.
• Install the miter guide (R).
• Set the miter guide to desired angle using the miter
guide scale, and tighten securely with lock knob.
• Place the material on the table and firmly against the
miter guide.
• Make sure the material is clear of the cutting wheel
before turning on the saw.
• Turn the on/off switch to the ON position.
• Let the cutting wheel build up to full speed and wait for the wheel to get wet before moving the material
into the wheel.
• Hold the material firmly against the miter guide and table fence. Feed the material into the cutting
wheel.
• When the cut is made, turn the saw OFF. Wait for the cutting wheel to come to a complete stop before
removing any part of the material.
Make an L-cut
L-cuts are cuts that remove a piece of tile to fit in
a corner, around a cabinet, or a piece of moulding and
are made by making two separate cuts.
Note: Only overcut on the bottom or underneath side of
the material being cut.
• Using a marker or grease pencil, mark the area to be
cut on material.
• Remove the miter gauge.
• Place the material on the table, firmly against the sliding
table fence.
• Make sure the material is clear of the cutting wheel
before turning on the saw.
• Turn the on/off switch to the ON position.
• Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into
the wheel.
24
kobalttools.com
Publicidad
