Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
• REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in the off position before
plugging in.
• DIRECTION OF FEED. Feed work into a cutting disc against the direction of rotation of the blade or
cutter only.
• NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. DO NOT leave tool until it
comes to a complete stop.
• The product may be used only when in a good working condition. If the product or part of the product
is defective, have it repaired by an expert.
• ALWAYS follow the applicable national and international safety, health and labor regulations.
• The product may only be used if no defects are found during the inspection. Ensure that any defective
parts are replaced before the product is used again.
• Position the product horizontally on a rigid, even surface with adequate load-bearing capacity.
• DO NOT leave any tools, objects, or cables lying in the working range of the device.
• Ensure that there is sufficient lighting during operation.
• Assume a natural and secure stance when working.
• Make sure that during operation, no body parts or clothing are caught and drawn in by rotating
components.
• The immediate environment must be free of combustible and other flammable or explosive substances.
• Young people under 18 years of age and users who are not sufficiently familiar with its operation
must not use the product.
• Persons unable to safely and carefully use the tool for physical, psychological, and neural reasons
must not use the product.
• Work with caution and only if you are physically fit. Working under the effects of fatigue, illness, alcohol,
medication and drugs is irresponsible, as you are unable to use the product safety.
SERVICE
• DISCONNECT TOOLS before servicing or when changing accessories, such as cutting discs.
• Have your electrical tool repaired only by qualified technicians, using only genuine spare parts. This
will maintain the safety of the electrical tool.
• DO NOT USE IN A DANGEROUS ENVIRONMENT. DO NOT use power tools in damp or wet locations,
or expose them to rain. Keep work area well lit.
• MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest performance.
• Follow instructions for lubricating and changing accessories.
• CHECK FOR DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged
should be carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any
other conditions that may affect operation. A guard or other part that is damaged should be properly
repaired or replaced.
• Only the maintenance work and troubleshooting activities described in these instructions may be carried
out. All other work must be carried out by an expert.
• Conversions, unauthorized modifications, and the use of non-approved parts are prohibited.
PRODUCT-SPECIFIC SAFETY WARNINGS
• Make sure that you ALWAYS stand to the side of the cutting disc.
• WEAR PROPER APPAREL. DO NOT wear loose clothing, gloves, neckties, rings, bracelets or other
jewelry that may get caught in moving parts. Nonslip footwear is recommended. Wear protective hair
covering to contain long hair.
6
kobalttools.com
Publicidad
