Edit Flame Setting- Follow the steps below to edit an existing Flame Setting
Duplicate Flame Setting - Follow the steps below to make a copy of a Flame Setting and save with new values
Delete Flame Setting
1. From the Flame Setup menu, select the checkbox next to the setting you wish to remove and press Delete Selected. NOTE: only one Flame Setting can
be deleted at a time.
2. Flame Settings cannot be deleted if they have been added to a Job Setting. (See Job Setup)
10
1. From the Flame Setup menu, select the checkbox next to the setting you
wish to change and press Edit Selected.
2. Change the Gas Type by selecting from the list (if necessary).
3. Turn the Fuel and Oxygen knobs ¼ turn clockwise to start gas flow. NOTE:
gas will not flow when editing a Flame Setting until the knobs are turned.
4. Ignite the torch. Adjust the Fuel and Oxygen until the desired ratio is
achieved.
5. Press Save to save the changes.
6. Provide a new name for the Flame Setting (if necessary) and press Enter. If
the Flame Setting name is not changing, simply press Enter on this screen
to save and return to the Flame Setup menu.
1. From the Flame Setup menu, select the checkbox next to the setting you
wish to change and press Edit Selected.
2. Change the Gas Type by selecting from the list (if necessary).
3. Turn the Fuel and Oxygen knobs ¼ turn clockwise to start gas flow. NOTE:
gas will not flow when editing a Flame Setting until the knobs are turned.
4. Ignite the torch. Adjust the Fuel and Oxygen until the desired ratio is
achieved.
5. Press Save as New. On the next screen, provide a name for the new Flame
Setting. NOTE: Flame Setting names must be unique.
6. Press Enter to save the record and return to the Flame Setup menu.