Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones página 13

3. Checking the saw blade lower limit position
Check that the saw blade can be lowered 13/32" to 7/16" (10mm to 11mm) below the table insert as shown in
Fig. 11-a.
When you replace a saw blade with a new one, adjust the lower limit position so that the saw blade will not cut
the turntable or complete cutting cannot be done.
To adjust the lower limit position of the saw blade, follow the procedures (1) indicated below. (Fig. 11-b)
Furthermore, when changing the position of a 8mm depth adjustment bolt that serves as a lower limit position
stopper of the saw blade.
(1) Turn the 8 mm depth adjustment bolt, change the height where the bolt head and the hinge contacts, and
adjust the lower limit position of the saw blade.
NOTE:
Confi rm that the saw blade is adjusted so that it will not cut into the turntable.
8mm Depth
adjustment bolt
Hinge
4. Lower limit position of saw blade when cutting a large workpiece
NOTE:
When cutting a workpiece exceeding 2-9/16" (65mm) in height in right-angle cutting or
1-25/32"(45mm) in left bevel angle cutting or 2-3/8" (60mm) in right bevel angle cutting,
adjust the lower limit position so that the base of the motor head (see Fig. 11-a) will not
come in contact with the workpiece.
6mm Depth
adjustment bolt
Turn
Hinge
Fig. 12
5. Confi rmation for use of sub fence
WARNING:
In the case of left bevel cutting, turn the sub fence counterclockwise. Unless it is
turned counterclockwise, the main body or saw blade may contact the sub fence,
resulting in an injury.
Turn
Left bevel
angle cutting
Sub Fence
Fence (B)
Fig. 13
Gear case
Saw blade
Turntable
Fig. 11-a
To adjust the lower limit position of the saw blade, follow the procedure
(1) shown in Fig. 12.
(1) Lower the motor head, and turn the 6 mm depth adjustment bolt
and make adjustments so that there can be a clearance of 5/64" to
1/8" (2 mm to 3 mm) between the lower limit position of the motor
head and the top of the workpiece at the saw blade's lower limit
position where the head of the 6 mm depth adjustment bolt contacts
the hinge.
Right bevel
This power tool is Equipped with a sub fence.
angle cutting
In the case of right angle cutting and right bevel angle cutting, use the
Right
angle cutting
sub fence. Then, you can realize stable cutting of the material with a
wide back face.
In the case of left bevel cutting, raise the sub fence up as illustrated in
Fig. 13 and then turn it counterclockwise.
Turn
Hinge
Fig. 11-b
English
8mm Depth
adjustment bolt
Gear case
13