Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones página 15

* Laser radiation- Do not stare into beam.
* Laser radiation on work table. Do not stare into beam.
If your eye is exposed directly to the laser beam, it can be hurt.
* Do not dismantle it.
* Do not give strong impact to the laser marker (main body of tool); otherwise, the
position of a laser line can go out of order, resulting in the damage of the laser
marker as well as a shortened service life.
* Keep the laser marker lit only during a cutting operation. Prolonged lighting of
the laser marker can result in a shortened service life.
* Use of controls or adjustments or performance of procedures other than those
specifi ed herein may result in hazardous radiation exposure.
NOTE:
* Perform cutting by overlapping the ink line with the laser line.
* When the ink line and the laser line are overlapped, the strength and weakness of light
will change, resulting in a stable cutting operation because you can easily discern the
conformity of lines. This ensures the minimum cutting errors.
* In outdoor or near-the-window operations, it may become diffi cult to observe the laser
line due to the sunlight. Under such circumstances, move to a place that is not directly
under the sunlight and engage in the operation.
* Do not tug on the cord behind the motor head or hook your fi nger, wood and the like
around it; otherwise, the cord may come off and the laser marker may not be lit up.
Laser line
Fig. 18
Saw Blade
Workpiece
Marking
(pre-marked)
Cutting Width
Fig. 19
Vise Assembly
Move
Laser Line
Groove Adjuster
Fig. 20
Fig. 17
Ink lining can be easily made on this tool to the laser marker. A switch
lights up the laser marker. (Fig. 18)
Switch
(For laser marker)
Depending upon your cutting choice, the laser line can be aligned with
the left side of the cutting width (saw blade) or the ink line on the right
side.
The laser line is adjusted to the width of the saw blade at the time of
factory shipment. Adjust the positions of the saw blade and the laser
line taking the following steps to suit the use of your choice.
(1) Light up the laser marker and make a groove of about 3/16" (5mm)
deep on the workpiece that is about 25/32" (20mm) in height and
5-29/32"(150mm) in width. Hold the grooved workpiece by vise as
it is and do not move it. For grooving work, refer to "11. Groove
cutting procedures" on page 22.
(2) Then, turn the adjuster and shift the laser line. (If you turn the
adjuster clockwise, the laser line will shift to the right and if you
turn it counterclockwise, the laser line will shift to the left.) When
you work with the ink line aligned with the left side of the saw
blade, align the laser line with the left end of the groove. (Fig. 20)
Turn
When you align it with the right side of the saw blade, align the
laser line with the right side of the groove.
English
15