Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones página 21

(1) Setting to cut crown moldings at positions 1 and 4 in Fig. 34 (see Fig. 36; tilt the motor head to the left):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the motor head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the upper surface (Ⓐ in Fig. 33) contacts the fence as indicated in Fig. 38.
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 34 (see Fig. 37; tilt the head to the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the lower surface (Ⓑ in Fig. 33) contacts the fence as in Fig. 39.
1
Miter angle scale
Fence
Ⓐ
Cutting method of crown molding without tilting the saw blade.
Crown molding Vise Ass'y Crown molding Stopper (R)
(optional accessories) (optional accessories)
6mm Knob
Bolt
6mm Knob Bolt
Crown molding Stopper (L)
6mm Wing Bolt
(optional accessories)
Fig. 40-a
Crown molding vise ass'y
(Optional accessories)
6mm knob bolt
Fence
Crown molding
6mm wing bolt
Fig. 40-b
Head
Bevel angle scale
Fence
4
Base
Turntable
Fig. 36
Ⓑ
Table on Base
Fig. 38
(1) Crown molding Stopper (L) and (R) (optional accessories) allow
easier cuts of crown molding without tilting the saw blade. Install
them in the base both-sides side to be shown in Fig. 40-a. After
inserting Tighten the 6mm knob bolts to secure the crown molding
Stoppers.
[Optional accessories used]
• Crown molding Vise Ass'y (Include Crown molding Stopper (L))
• Crown molding Stopper (L)
• Crown molding Stopper (R)
(2) The crown molding vise (B) (Optional accessory) can be mounted
on either the left fence (Fence (B)) or the right fence (Fence (A)).
It can unite with the slope of the crown molding and vice can be
pressed down.
Then turn the upper knob, as necessary, to securely attach the
crown molding in position. To raise or lower the vise assembly,
Knob
fi rst loosen the 6mm knob bolt.
After adjusting the height, fi rmly tighten the 6mm wing bolt; then
turn the upper knob, as necessary, to securely attach the the
crown molding in position. (see Fig. 40-b)
Crown molding stopper (L)
Crown molding stopper (R)
(Optional accessories)
Head
Bevel angle scale
3
Fence
2
Base
Miter angle scale
Turntable
Fig. 37
Fence
Ⓐ
Ⓑ
Table on Base
Fig. 39
English
21