Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones página 19

7. Bevel cutting procedures
Holder (A)
Set pin
Indicator
(For bevel scale)
Pull
Bevel scale
Fig. 29
WARNING:
When the workpiece is secured on the left or right side of the blade, the short cut-
off portion will come to rest on the right or left side of the saw blade. Always turn
the power off and let the saw blade stop completely before raising the handle from
the workpiece.
If the handle is raised while the saw blade is still rotating, the cut-off piece may
become jammed against the saw blade causing fragments to scatter about
dangerously.
When stopping the bevel cutting operation halfway, start cutting after pulling back
the motor head to the initial position.
Starting from halfway, without pulling back, causes the lower guard to be caught in
the cutting groove of the workpiece and to contact the saw blade.
CAUTION:
When cutting a workpiece of 1-15/16" (50mm) height in the left 45° bevel cutting
position or a workpiece of 2-3/4" (70mm) height in the right 5° bevel cutting position,
adjust the lower limit position of the motor head so that the gap between the lower
edge of the motor head and the workpiece will be 5/64" to 1/8" (2 to 3mm) at the
lower limit position (refer to "3. Checking the saw blade lower limit position" on
page 13).
8. Miter cutting procedures
Indicator
(For miter scale)
Turntable
Turn the
turntable
Miter Scale
Lever
Pull up
Fig. 30
Angle Scale
Grade Scale
Miter Scale
Fig. 31
Fig. 32
(1) Loosen the clamp lever and bevel the saw blade to the left or
to the right.
When tilting the motor head to the right pull the set pin towards
the rear.
(2) Adjust the bevel angle to the desired setting while watching the
bevel angle scale and indicator, then secure the clamp lever.
Clamp
(3) Follow the procedures indicated in paragraphs 4,5 and 6
lever
above. For maximum dimensions for bevel cutting, refer to
"SPECIFICATIONS" table on page 8.
Tighten
Loosen
(1) Loosen the side handle and pull up the lever for angle stoppers.
Then, adjust the turntable until the indicator aligns with desired
setting on the miter scale (Fig. 30).
Side Handle
(2) Re-tighten the side handle to secure the turntable in the desired
position.
Tighten
(3) The miter scale (Fig. 31) indicates both the cutting angle on the
angle scale and the gradient on the grade scale.
(4) The gradient, which is the ratio of the height to the base of the
Loosen
triangular section to be removed, may be used for setting the
miter scale instead of the cutting angle, if desired (see Fig. 31).
(5) Therefore, to cut a workpiece at a grade of 2/10, set the indicator
to position ⓐ as indicated in Fig. 31.
NOTE:
ⓐ
* Positive stops are provided at the right and left of
the 0° center setting, at 15°, 22.5°, 31.6° and 45°
settings.
Check that the miter scale and the tip of the indicator
are properly aligned.
* Operation of the saw with the miter scale and
indicator out of alignment, or with the side handle
not properly tightened, will result in poor cutting
precision.
English
19