Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones página 22

English
WARNING:
CAUTION:
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT
EDGE against the crown molding Stoppers as shown in Fig. 40-b.
Adjust the crown molding Stoppers according to the size of the crown molding.
Tighten the 6mm wing bolt to secure the crown molding Stoppers.
Refer to the lower table for the miter angle.
For inside corner
For outside corner
11. Groove cutting procedures
Grooves in the workpiece can be cut as indicated in Fig. 41 by adjusting the 6mm depth adjustment bolt.
Cutting depth adjustment procedure:
(1) Lower the motor head, and turn the 6 mm depth adjustment bolt by hand. (Where the head of the 6 mm
depth adjustment bolt contacts the hinge.)
(2) Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of the
base (see b in Fig. 41).
(3) The 8mm wing nut must be properly tightened after the adjustment has been completed.
NOTE:
When cutting a single groove at either end of the workpiece, remove the unneeded portion
with a chisel.
12. Using the Light (Only Model C8FSHE
WARNING:
CAUTION:
22
Always fi rmly clamp or vise to secure the crown molding to the fence; otherwise the
crown molding might be thrust from the table and cause bodily harm.
Do not bevel cutting. The main body or saw blade may contact the sub fence,
resulting in an injury.
Always confi rm that the motor head (see Fig. 1) does not contact the crown molding
vise ass'y when it is lowered for cutting. If there is any danger that it may do so,
loosen the 6mm knob bolt and move the crown molding vise ass'y to a position
where it will not contact the saw blade.
Position in Fig. 34
1
2
3
4
Cut grooves with saw blade
ⓐ
ⓑ
Fig. 41
Check to ascertain that the main unit and light are off before plugging the cord into
the power socket.
The light lens reaches high temperatures during and immediately after use and
should not be touched under any circumstances.
Failure to observe this may result in burns.
Do not subject the light to strong impact.
Failure to observe this may result in damage to the light or a reduced life span.
Only switch the light on when cutting.
Do not shine the light continuously into the eyes.
Failure to observe this may result in damage to the eyes.
Wipe all dirt that adheres to the light lens with a soft cloth gently so that the light is
not scratched or damaged.
Scratches on the light lens may result in less luminance.
The light switch is fi tted with an anti-dust cover. Make sure that the switch cover is
not scratched or otherwise damaged.
There are cases in which shavings may enter the switch and prevent the light from
functioning.
Miter angle
Right 45°
Left 45°
Right 45°
6mm Depth
adjustment bolt
Hinge
C8FSHE(S))
•
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
Turn
Fig. 42