Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones página 14

English
6. Oblique angle
Before the power tool is shipped from the factory, it is adjusted for 0°, right angle, left 45° bevel cutting angle
with the 8mm bolt (A) and 8mm bolt (B).
When changing the adjustment, change the height of the 8mm bolt (A) or 8mm bolt (B) by turning them.
When changing the bevel angle to the left 45° and over, pull the set pin on the direction shown in Fig. 14-a and
incline the motor head to the left.
When changing the bevel angle to the right, pull the set pin on the direction shown in Fig. 14-a and incline the
motor head to the right.
When adjusting the motor head to 0°, always return the set pin to its initial position as shown in Fig. 14-b.
Indicator
(For bevel scale)
8mm Bolt (B)
(Stopper for left 45° bevel angle)
7. Securing the workpiece
WARNING:
Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
8. Installing the sub table
8 mm bolt
6 mm knob bolt
Steel
square
Holder
Height adjustment
bolt 8 mm
Fig. 15
9. Position adjustment of laser line (Only Model C8FSHE
WARNING:
CAUTION:
14
Set pin
Pull
Fig. 14-a
Using an item such as a steel square, match the upper surfaces of the
base surface and sub table. Adjust the vertical level of the sub table by
turning the 8 mm height adjustment bolt. After the adjustment, secure
the holder with the 8 mm bolt on the rear of the base, and secure the 6
mm knob bolt of the sub table.
Always use the sub table during operation and fi x properly with 8 mm
bolt. (Fig. 15)
Base surface
Sub table
* Make sure before plugging the power plug into the receptacle that the main body
and the laser marker are turned off .
* Exercise utmost caution in handling a switch trigger for the position adjustment of
the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in
unexpected accidents.
* Do not remove the laser marker to be used for other purposes.
Fig. 16
Return
Set pin
Fig. 14-b
C8FSHE(S))
•
8mm bolt (A)
(Stopper for 0°)